instruction sheet extraction tool 2063080- 1 408--10329 loc b 1 of 1 e 2009 tyco electronics corporation, harrisburg, pa all international rights reserved te logo and tyco electronics are trademarks. *trademark. other products, logos, and company names used are the property of their respective owners. tooling assistance center 1--800--722-- 1111 product information 1--800--522--6752 this controlled document is subject to change. for latest revision and regional customer service, visit our website at www.tycoelectronics.com 30 oct 09 rev a for multi- beam xl* connectors figure 1 handle two--pronged tip 1. introduction extraction tool 2063080--1 is used to remove individual contacts from multi--beam xl connectors (reference part number 292499--1). 2. description the extraction tool is a handle with a two--pronged tip. see figure 1. when inserted in the contact cavity of the connector, the tip will spread the locking latches of the contact apart. this will enable the contact to be pulled out from the wire end of the connector. 3. using the tool 1. at the mating face of the connector, align the tip of the tool with the contact cavity of the contact to be removed. see figure 2. 2. push the tip into the contact cavity until it bottoms on the connector. 3. holding the tool in place, gently pull the wire of the contact until it is out of the connector. contacts can be re--used if they are not deformed or damaged. 4. replacement and repair the extraction tool is not repairable. order replacements through your representative, or call 1--800--526--5142, or send a facsimile of your purchase order to 717--986--7605, or write to: customer service (038--035) tyco electronics corporation po box 3608 harrisburg pa 17105--3608 figure 2 1 2 3 using the tool mating face of connecto r tool bottomed on connector gently pull wire to extract contact note i
|
